Ccd barcode scanner programming manual

Loop of Programming The procedure of programming parameters is shown on the flow chart. Basically it is implemented by: 1. Scan “Start Configuration”. 2. Scan all necessary barcodesfor parameters that meet applications. 3. Scan “End Configuration” to end the programming. 4. To permanently save the parameters, scan “Save Parameters”. To program the //, you must scan a series of programming barcode in the correct order. Fold out the back cover of this manual. You will see a table of alphanumeric barcodes, which are used to program the various options presented. To program each option, you must: 1. Scan the Program barcode on the parameter setting part. 2. review this manual before scanning any of the programming bar codes in this manual. The Wasp Charged Coupled Device (CCD) technology is a technique whereby a bar code is photographed, digitized, and electronically sampled by built-in Use the Factory Defaultbar code to reset the scanner to the Default settings. PC - AT (PS/2) * PC - XT.

1 www.doorway.ru virtuos@www.doorway.ru Virtuos v ENG Programming User’s Manual 2D Wireless Barcode Scanner HWA Restore default CCD module. The GHz Barcode Scanner can ONLY be used as a wireless scanner. Wireless Please Note: Use the provided pin or something sharp to reach the disassembling hole if you want to get the USB cable and the scanner body separated. 2 in 1 can be used as a wirelss or a wired Bar code Scanner. Part One: Basic Descriptions and Settings for. Barcode Overview and Scanning Procedure. Manual scanning mode: 1. Press and hold the trigger button. 2. Position the center of the codes under the light, and move the scanner between the codes to find the best scanning distance. 3. Decoding (reading) is complete when the buzzer sounds and the lights turn off.

In its default state, it can discern about 20 different symbologies. Barcode Overview and Scanning. Procedure. Manual scanning mode: 1. Press and hold the. Wireless Linear CCD Barcode Scanner Chapter 4: Scanner Configuration Main Settings With the basics of the flow chart from chapter 2 in mind, use the following. Below is the programming procedure for using barcodes in this guide. 1. Power up the scanner. 2. Scan the Start of Configuration barcode. 3.